Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.
Search found 5 matches
- August 11th, 2016, 7:51 am
- Forum: Current Sources
- Topic: How to switch off 6221 output after a sweep.
- Replies: 1
- Views: 11622
How to switch off 6221 output after a sweep.
Hello I use the realterm console program via a serial interface (hardware handshaking) to drive a 6221. I want a program that sets the current from the 6221 as follows: 1. -10pA or any small value for 1 second. This is just a dummy/setup point. 2. then +10mA for 0.03 seconds 3. then I want the outpu...
- July 1st, 2013, 2:38 am
- Forum: Other Keithley Instrument Products
- Topic: RTS input on Keithley 6221 ignored
- Replies: 4
- Views: 22371
Re: RTS input on Keithley 6221 ignored
Hello Norbert Thank you for the response. In a nutshell: RTS is an information signaling that the PC has commands for the 6221 (waiting for CTS before it really starts to send them), it’s not intended to stop data being sent from the 6221. I fully understand this comment and I am willing to accept t...
- June 13th, 2013, 10:33 am
- Forum: Other Keithley Instrument Products
- Topic: RTS input on Keithley 6221 ignored
- Replies: 4
- Views: 22371
Re: RTS input on Keithley 6221 ignored
Hello Mark Thank you for quick response. I have discussed the serial port definition in the Keithley 6221 document with Dale C in the past. Keithley do not stick to the official RS232 standard if that standard actually ever existed. I base my interpretation of the standard on the sources found in th...
- June 13th, 2013, 8:13 am
- Forum: Other Keithley Instrument Products
- Topic: RTS input on Keithley 6221 ignored
- Replies: 4
- Views: 22371
RTS input on Keithley 6221 ignored
Hello I emailed this question to on the 7th of June to this email address ([email protected].com) I had no response. Maybe I should have posted this on the forum from the beginning. Here we go... __________________________________ Look at the attached - in the pdf file. 1. I have enabled HW f...
- September 6th, 2012, 4:15 am
- Forum: Current Sources
- Topic: Erroneous current outputs during customs sweep
- Replies: 1
- Views: 11124
Erroneous current outputs during customs sweep
I need help. I have a brand new Keithley 6221 set to all its default factory settings. The default Triax connections are used which is Current Source Lo connected to inner shield and Outer shield connected to earth ground. The inner shield and outer shield is not connected, i.e. the current source i...