Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.

Search found 4 matches

by sausgh
May 15th, 2015, 9:07 am
Forum: Low Voltage Measurements
Topic: 2182A Nanovoltmeter Channel2 Lo wire problem and reading dat
Replies: 3
Views: 17499

Re: 2182A Nanovoltmeter Channel2 Lo wire problem and reading

Thank you Joseph, I try to do the way you said. its fine now. Actually I was missing to make the contact between the two point which is connected to the thermocouples. Now when the two copper block in touch then I saw both the channel is reading the voltage as well temperature accurately. Thanks a l...
by sausgh
May 15th, 2015, 8:49 am
Forum: Low Voltage Measurements
Topic: 2182A Nanovoltmeter Channel2 Lo wire problem and reading dat
Replies: 3
Views: 17499

Re: 2182A Nanovoltmeter Channel2 Lo wire problem and reading

Dear Joseph, initially it was not the problem. Both channel were doing independent measurement of voltage and temperature, now they are not doing independent. that means if i connect independently both channel with two different thermocouple then first channel will show the data but second channel w...
by sausgh
May 15th, 2015, 8:04 am
Forum: Low Voltage Measurements
Topic: 2182A Nanovoltmeter Channel2 Lo wire problem and reading dat
Replies: 3
Views: 17499

2182A Nanovoltmeter Channel2 Lo wire problem and reading dat

Dear All, I am research scholar working with Keithley Nanovoltmeter 2182A nanovoltmeter. I have faced following problem and try to know the exact fault in the system. I need a technical help from technical expertise. If you know the email Id or contact detail then you can help me. Since I am not get...
by sausgh
February 8th, 2015, 6:53 am
Forum: Nanovoltmeters
Topic: Reading 2 channel data simultaneously in 2182A nanovoltmeter
Replies: 1
Views: 13320

Reading 2 channel data simultaneously in 2182A nanovoltmeter

Dear All, I wrote a simple Labview program to read the voltage. I did it for one channel and it is measuring fine way. My purpose is to measure the voltage at two point at the same time, so I need to read the voltage at both channel at a time. Anyone can help me regarding this. Thanks & Regards Saur...

Go to advanced search