Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.

Search found 3 matches

by Ellaine
February 4th, 2017, 2:30 pm
Forum: 4200-SCS Semiconductor Parameter Analyzer
Topic: NVM pramSweep problems (want to add stop condition and failed to change current range)
Replies: 5
Views: 17201

Re: NVM pramSweep problems (want to add stop condition and failed to change current range)

Hello Vince, Thank you very much for your reply. I can change the current range now. However, the measurement data (e.g. setI) looks pretty weird. It shows low current ~e-6 even I've pad two probes on the same metal pads (I've verified by SMU DCsweep, and it does show very high current~1e-2). How ca...
by Ellaine
February 2nd, 2017, 10:52 am
Forum: 4200-SCS Semiconductor Parameter Analyzer
Topic: NVM pramSweep problems (want to add stop condition and failed to change current range)
Replies: 5
Views: 17201

Re: NVM pramSweep problems (want to add stop condition and failed to change current range)

Hi Vince, The KTEI 9.0 was used, which is the one I failed to change the current range (we do have 4225-RPM remote modules). But then we upgraded it to 9.1 , right now it works!!! Thanks a lot!! I still have some inquiries: I checked the original codes of pramsweep where PULS_MEAS_WFM_PER mode is us...
by Ellaine
January 31st, 2017, 9:54 am
Forum: 4200-SCS Semiconductor Parameter Analyzer
Topic: NVM pramSweep problems (want to add stop condition and failed to change current range)
Replies: 5
Views: 17201

NVM pramSweep problems (want to add stop condition and failed to change current range)

Hello, I have two questions about the pramSweep user module in nvm user library. The first one is: Normally, this module looks like a measurement iteration (for loop) and I can see the measurement data keeps showing up in the data sheet until it reaches the user-defined data size (default 40). And i...

Go to advanced search