Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.

Search found 4 matches

by robertmgreen
May 3rd, 2017, 5:43 am
Forum: Low Current Measurements
Topic: Needing Help GPIB and VB.NET (Semiconductors)
Replies: 4
Views: 14379

Re: Needing Help GPIB and VB.NET (Semiconductors)

Good morning.

I sometimes go here for help......

http://www.codeproject.com

The site is a gold mine for programming issues large and small. Membership is free and help is endless.

Good luck.
by robertmgreen
May 3rd, 2017, 5:26 am
Forum: General Discussion
Topic: Tektronix DM-5010
Replies: 4
Views: 15933

Re: Tektronix DM-5010

After spending countless hours scouring the 5010 manual, I found an adjustment procedure in Section 6 that includes the jumper settings for proper calibration. Following that procedure cleared the error code 351; however, the error returned the next day after being powered down overnight, leading me...
by robertmgreen
April 12th, 2017, 9:36 am
Forum: General Discussion
Topic: Tektronix DM-5010
Replies: 4
Views: 15933

Re: Tektronix DM-5010

Many thanks. I have an old hard copy of this manual. So far, haven't found anything that would help. Wish I had known about the link earlier, though. Had to go to Greece to get a CD copy in case my hard copy became too tattered to use.
by robertmgreen
April 12th, 2017, 8:16 am
Forum: General Discussion
Topic: Tektronix DM-5010
Replies: 4
Views: 15933

Tektronix DM-5010

I use the DM-5010 programmable multimeter in vintage Automated Test Equipment for the troubleshooting and repair of circuit card assemblies. Recently when this item has been sent (in working order) to the local calibration facility, it has been returned with an op code error 351 (cal check sum error...

Go to advanced search