Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.

Search found 4 matches

by francesco.barbon
July 2nd, 2020, 8:45 am
Forum: Resistivity Measurements
Topic: Resistance measurement during pulses
Replies: 5
Views: 629

Re: Resistance measurement during pulses

Thanks Andrea, I am aware about the integrating topic. This is the rule :| I will try to convert everything to TSP soon, if I not get out of the topic. By the way, I got this code working: *RST :SOURce:FUNC CURRent; :SENSe:DIGitize:FUNCtion "VOLTage"; :ROUTe:TERMinals REAR; :SENSe:DIGitize:VOLTage:R...
by francesco.barbon
July 1st, 2020, 6:24 am
Forum: Resistivity Measurements
Topic: Resistance measurement during pulses
Replies: 5
Views: 629

Re: Resistance measurement during pulses

There are some videos and sample code that might help: https://forum.tek.com/viewtopic.php?f=263&t=142177#p288517 Using the measure R function is just a short hand. The reported R will still be dependent on the underlying I and V values. No accuracy improvements, etc. The examples I point you to ma...
by francesco.barbon
June 24th, 2020, 4:50 am
Forum: Resistivity Measurements
Topic: Resistance measurement during pulses
Replies: 5
Views: 629

Re: Resistance measurement during pulses

Hi Andrea, thanks for the reply, I gave a look on your material. Am I forced to use the digitalizer function for the pulses in the extended mode? Because I would need at the end only a single point per pulse. However, this could be the reason because I am struggling to get my code working for curren...
by francesco.barbon
May 8th, 2020, 9:13 am
Forum: Resistivity Measurements
Topic: Resistance measurement during pulses
Replies: 5
Views: 629

Resistance measurement during pulses

Dear colleagues, I have a setup with a 2461 SMU, and I have to characterize resistors (0.5-2 Ohm) during current pulses with amplitude 1-10 A and pulses width 1-5 ms. The current software measures the voltage through the sense line and get the readout of the current sourced. The IV values are then u...

Go to advanced search