Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.

Search found 7 matches

by Kanu04
January 12th, 2011, 10:39 am
Forum: 2400 Series SourceMeter
Topic: Could sourcemeter be controlled externally ?
Replies: 5
Views: 20864

Re: Could sourcemeter be controlled externally ?

Hi Tom,

Thanks for your reply. I have one more question. Which type of connector will I need if I have to send triggering clock input to sourcemeter from a PC ?

Regards,
Kanu
by Kanu04
January 11th, 2011, 8:58 am
Forum: 2400 Series SourceMeter
Topic: Could sourcemeter be controlled externally ?
Replies: 5
Views: 20864

Re: Could sourcemeter be controlled externally ?

Hi Tom, I went through the 11th chapter. What I understand is that there is a trigger needed for all the three actions, namely, source , delay and measure. According to our requirements, we have to source the DUT continuously and measure the output current after regular intervals (which I think can ...
by Kanu04
January 10th, 2011, 12:55 pm
Forum: 2400 Series SourceMeter
Topic: Could sourcemeter be controlled externally ?
Replies: 5
Views: 20864

Could sourcemeter be controlled externally ?

Hi All,

We are basically performing an experiment where sourcemeter is measures the current of digital output of DUT. Our requirement is to measure the current at the triggering edge of clock of the device. So I was wondering if it is possible to set a clock for the device ?

Thanks,
Kanu
by Kanu04
January 3rd, 2011, 2:50 pm
Forum: 2400 Series SourceMeter
Topic: GUI for SCPI program ?
Replies: 5
Views: 22195

Re: GUI for SCPI program ?

Hi Tom, I have a very basic doubt about the sourcemeter. Since we are supposed to provide signals to our device under test, I was just wondering what is the function of sourcemeter ? Is it just to provide VDD or signals as well ? In fact what does Source V, Measure I mean ? I have got literally conf...
by Kanu04
December 27th, 2010, 10:50 am
Forum: 2400 Series SourceMeter
Topic: GUI for SCPI program ?
Replies: 5
Views: 22195

Re: GUI for SCPI program ?

Hi All,

I think I found answer to my previous questions. I looked for Labview drivers on this site. I have one more question. I know that sampling frequency can be set for the input we provide. How do I measure the same for the output waveforms ?

Thanks,
Kanu
by Kanu04
December 27th, 2010, 9:57 am
Forum: 2400 Series SourceMeter
Topic: GUI for SCPI program ?
Replies: 5
Views: 22195

Re: GUI for SCPI program ?

Hi Tom, I did a few searches and downloaded the VB.NET for to communicate using RS232. But you mentioned that it could be done through Lab View as well. Is there any documentation for that ? Further we need to trigger the sourcemeter too using Lab View or Signal Express. It will really helpful if I ...
by Kanu04
December 19th, 2010, 3:07 pm
Forum: 2400 Series SourceMeter
Topic: GUI for SCPI program ?
Replies: 5
Views: 22195

GUI for SCPI program ?

Hi All, We are using 2400 series sourcemeter for our lab equipment. We want to interface to the PC through RS232. After reading the manuals, I understand that the programming can be done using SCPI commands. I was wondering what GUI do I need for programming ? I appreciate it someone can help me out...

Go to advanced search