Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.

2400 SMU unresponsive via GPIB (timeout) after READ? or FETCh? command

Models 2400, 2401, 2410, 2420, 2425, 2430, 2440, 6430
Post Reply
Felisnigripes
Posts: 1
Joined: August 4th, 2021, 6:57 am
Country: Germany

2400 SMU unresponsive via GPIB (timeout) after READ? or FETCh? command

Post by Felisnigripes » August 4th, 2021, 7:02 am

Hello,

I am trying to set up an I-V sweep using the 2400 SMU connected via GPIB with Matlab.

Code: Select all

fprintf(obj,['*RST']);          
source_range = 1E-3;
meas_range = 2;
fprintf(obj,[':SOUR:FUNC CURR']); 
fprintf(obj,[":SENS:FUNC 'VOLT:DC'"]);
fprintf(obj,[':SOUR:CURR:START 0E-6']);
fprintf(obj,[':SOUR:CURR:STOP 1E-3']);
fprintf(obj,[':SOUR:CURR:STEP 100E-6']);
fprintf(obj,[':SOUR:CURR:MODE SWE']);   
fprintf(obj,[':SOUR:CURR:RANG ' num2str(source_range)]);
fprintf(obj,[':SOUR:VOLT:RANG ' num2str(meas_range)]); 
fprintf(obj,[':SOUR:SWE:SPAC LIN']);
numpoints = query(obj, "SOUR:SWE:POIN?");
fprintf(obj,[':TRIG:COUN ' numpoints]);
fprintf(obj,[':SOUR:DEL 0.1']);

fprintf(obj,[':OUTP ON']);

fprintf(obj,':INIT')    
query(obj,':FETC?')  

fprintf(obj,[':OUTP OFF']);
However, after the 'FETC?' command, the SMU becomes unresponsive to any Matlab command. Switching to LOCAL on the front panel makes it responsive again.

Why is this and how can I fix this issue?

Post Reply

Return to “2400 Series SourceMeter”

Who is online

Users browsing this forum: No registered users and 1 guest