Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.
so on, I wanna set up a high resistance measurement.
Current should be sourced on the Keithley 6430, measuring with the Keithely 2000 and so on calculating resistance.
Is it possible to use this devices in combination?
Keithley 6430 Low-Noise Triax cable to 3 alligator clips
Keithley 8607 2-wiresource banana test cables
Mainframe connection cable between PreAmp and 6430
I don´g get the values, maybe it´s just the contact of the probe and DUT (very small).
Also, it could be the wrong probes.
Maybe one of you knowing my set up and knows hints.
I hope my info and questions are clear!
Thank you in attend
- Keithley Applications
- Posts: 1280
- Joined: October 15th, 2010, 10:35 am
- Country: United States
Your 6430 SourceMeter can most likely perform the measurement by itself. Have a look in the Reference manual and DUT connections.
If the DUT ohms is less than 100 ohms, consider using 4-wire connections.
Who is online
Users browsing this forum: No registered users and 3 guests