Hi there,
I am using Keithley 6430 as a voltage source to provide voltage sweep from -100V to +100V. However, I found the voltage sweep range cannot be set as negative values from the front panel. Is keithley 6430 capable of doing it? If so, how to do it?
Thank you!
Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.
Voltage sweep start from negative values
-
[email protected]
- Posts: 1
- Joined: December 18th, 2017, 10:03 am
- Country: United States
Re: Voltage sweep start from negative values
Hi dgbbo,
Yes you certainly can. What you will need to do is while setting the start/stop voltages you will need to press the little blue EDIT button and then press the CONFIG button which has the little blue +/- over it. This will change the value between positive an negative.
Yes you certainly can. What you will need to do is while setting the start/stop voltages you will need to press the little blue EDIT button and then press the CONFIG button which has the little blue +/- over it. This will change the value between positive an negative.
Who is online
Users browsing this forum: No registered users and 3 guests