Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.
I created a VI for resistance measurement in 4-wire mode. A number of resistors are being measured by Keithley through multiplexer. See LabView diagram below.
Enable Remote Sensing.vi gives erorr 1074000000. Everything works fine if I disconnect error wire after Enable Remote Sensing.vi or modify Enable Remote Sensing.vi by removing Error Query.vi out of it.
Could anyone give me a clue why Enable Remote Sensing.vi gives the erorr?
- Enable Remote Sensing_VI gives error 1074000000.jpg (94.67 KiB) Viewed 783 times
Who is online
Users browsing this forum: No registered users and 1 guest