Page 1 of 1

Keithley 2400, Enable Remote Sensing.vi gives erorr 1074000000 in LabView

Posted: November 1st, 2018, 6:05 am
by Mikhan
I have Keithley 2400 with C34 firmware, Windows 10, Labview 2015.
I created a VI for resistance measurement in 4-wire mode. A number of resistors are being measured by Keithley through multiplexer. See LabView diagram below.
Enable Remote Sensing.vi gives erorr 1074000000. Everything works fine if I disconnect error wire after Enable Remote Sensing.vi or modify Enable Remote Sensing.vi by removing Error Query.vi out of it.
Could anyone give me a clue why Enable Remote Sensing.vi gives the erorr?