Page 1 of 1

Stop at compliance without sweep

Posted: April 1st, 2011, 12:03 am
by noddle
Hi,
I use Keithley 2410 source-meter to do TDDB measurement. I want this source-meter stop at current compliance.

I have tried to put this code

:STAT:MEAS:ENAB 16384
*SRE 1
:ABOR
:STAT:MEAS?
*SRE 0

but it didnot work. Any help would be greatly appreciated.

Re: Stop at compliance without sweep

Posted: April 1st, 2011, 7:34 am
by Dale C
Are you doing a sweep?
If so then use the compliance abort command.
:SOURCE:SWEEP:CABORT (NEVER,EARLY or LATE).
If not using a sweep then you could also use the trip command.
:SENSE:CURRENT:PROTECTION:TRIPPED?
This would return a yes(1) or no(0) when addressed to talk.