Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.

How to display pulsed measurement on 2612A

Models 2601, 2602, 2611, 2612, 2635, 2636
Models 2601A, 2602A, 2611A, 2612A, 2635A, 2636A
Models 2601B, 2602B, 2604B, 2611B, 2612B, 2614B, 2634B, 2635B, 2636B
Post Reply
Posts: 93
Joined: September 23rd, 2014, 6:14 am
Country: United States

How to display pulsed measurement on 2612A

Post by jaime_g » October 27th, 2017, 10:57 am

A 2612A is configured to perform a current gain measurement on an PNP transistor.
Channel A sources a negative 500µs current pulse. The pulse level, starting at -600µA is increased to -850µA in 1µA steps. The interval between 1µA steps is 100ms. The source changing amplitude is displayed on the bottom left on the SrcA field.
Channel B sources -10V to the collector with the compliance level set to -150mA. How can the pulsed collector current be displayed during this operation?

i would appreciate your feedback and suggestions.

Andrea C
Keithley Applications
Keithley Applications
Posts: 1548
Joined: October 15th, 2010, 10:35 am
Country: United States

Re: How to display pulsed measurement on 2612A

Post by Andrea C » October 31st, 2017, 10:42 am

Try this command: display.smub.measure.func = display.MEASURE_DCAMPS

Post Reply

Return to “2600 Series SourceMeter”

Who is online

Users browsing this forum: No registered users and 1 guest