Page 1 of 1

How to display pulsed measurement on 2612A

Posted: October 27th, 2017, 10:57 am
by jaime_g
A 2612A is configured to perform a current gain measurement on an PNP transistor.
Channel A sources a negative 500µs current pulse. The pulse level, starting at -600µA is increased to -850µA in 1µA steps. The interval between 1µA steps is 100ms. The source changing amplitude is displayed on the bottom left on the SrcA field.
Channel B sources -10V to the collector with the compliance level set to -150mA. How can the pulsed collector current be displayed during this operation?

i would appreciate your feedback and suggestions.

Re: How to display pulsed measurement on 2612A

Posted: October 31st, 2017, 10:42 am
by Andrea C
Try this command: display.smub.measure.func = display.MEASURE_DCAMPS