Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.

set_mode command

Post Reply
Posts: 1
Joined: July 23rd, 2020, 10:35 pm
Country: Israel

set_mode command

Post by Dima92 » July 29th, 2020, 3:12 am

Can somebody explain how i should use set_mode function with KI_AUTO_GND_PINS modifier in order to connect all unused pins to ground?
Can I write it in this way:

Andrea C
Keithley Applications
Keithley Applications
Posts: 1548
Joined: October 15th, 2010, 10:35 am
Country: United States

Re: set_mode command

Post by Andrea C » August 11th, 2020, 9:37 am

What model tester is this?
I would think a conpin() type command is more appropriate than set_mode().

Post Reply

Return to “Low Current Measurements”

Who is online

Users browsing this forum: No registered users and 1 guest