Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.

Error -113 operating 2182A with Labview

Post Reply
Julia_s
Posts: 1
Joined: November 6th, 2015, 10:05 am
Country: United States

Error -113 operating 2182A with Labview

Post by Julia_s » November 12th, 2015, 10:15 am

Hello,

I am reading a thermocouple off of channel 2 of my NanoVoltmeter using a Labview VI that I wrote. It successfully reads temperature but at each reading error -113 pops up on the voltmeter display panel. I cannot figure out what my syntax error is and the beeping is less than ideal. Below is a - of my commands sent to the nanovoltmeter that is generating the error. Any help in correcting the syntax would be greatly appreciated. I also tried clearing the error queue but that did not get rid of the error.
Thermocouple error.PNG
Thermocouple error.PNG (10.49 KiB) Viewed 11933 times
Thank you.

Dale C
Keithley Applications
Keithley Applications
Posts: 2849
Joined: June 10th, 2010, 6:22 am
Country: United States
Contact:

Re: Error -113 operating 2182A with Labview

Post by Dale C » November 16th, 2015, 5:31 am

The first command should not have an 'S" at the TRAN.
It should be :sense:temp:tran tc
That should do it.

Post Reply

Return to “Low Voltage Measurements”

Who is online

Users browsing this forum: No registered users and 2 guests