Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.

KULT manual?

Post Reply
irathbun
Posts: 1
Joined: October 9th, 2018, 11:36 am
Country: United States

KULT manual?

Post by irathbun » October 9th, 2018, 12:12 pm

I am trying to write a routine to apply a bias from an SMU and at the same time pulses from an HP8110. On the scope I see the SMU bias being applied and then it stops and the pulses begin. How can I keep the SMU bias going until the pulses stop? I put a delay command but it doesn't seem to cause enough of a delay to keep the smu from stopping.

Is there any KULT manual that describes the various commands in detail?

Post Reply

Return to “4200-SCS Semiconductor Parameter Analyzer”

Who is online

Users browsing this forum: No registered users and 1 guest