Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.

2281S-20-6 Measuring voltage/current in battery charge mode

2280S-32-6, 2280S-60-3
Post Reply
Posts: 1
Joined: October 4th, 2018, 1:17 pm
Country: United States

2281S-20-6 Measuring voltage/current in battery charge mode

Post by dmcneill » October 4th, 2018, 1:27 pm

I would like to record the voltage and current over an entire battery charging cycle - it takes about 85 minutes, so sample every 2 seconds say to fill up the 2500 point buffer.
I can't see how to do this directly from the instrument front panel, so I am trying to do this through SCPI commands.
After reset, I issue the commands:


which seems to work ok. Then, I want to set up the trigger such that whenever I send the *TRG command, it will make a measurement and put the result in the buffer. But when I send the command:


I get an error message that this command is not allowed in this mode - in fact, it seems to only work in the POWer mode. Any help or pointers would be appreciated. Thank you,

Post Reply

Return to “Series 2280 Precision Measurement DC Power Supplies”

Who is online

Users browsing this forum: No registered users and 1 guest