Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.
i need to measure 4 wire resistance reading from 20 channels in 4 wire from 7001 with 7011 scanner card.
I close the required channels from 1 to 20 one by one.
Then after each channel is closed, i need to direct the K2001 to scan that closed channel. (ex 1!1 or 1!8 etc)
In the present driver provided in the keithley website, there is no provision to input the scan address.
- Keithley Applications
- Posts: 108
- Joined: September 22nd, 2010, 12:27 pm
- Country: United States
Please provide the specific Keithley LV driver call you are calling and the arguments you are passing. Then, please provide the arguments you do not have that would satisfy your requirements. I do not fully understand the gaps in our LV driver that you are describing.
A Greater Measure of Confidence
Who is online
Users browsing this forum: No registered users and 2 guests