Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.
But it always gets error "step size too small".
See the following laview code. With "*RST" before the code, I always get that error.
Without "*RST" ahead, I may get the settings (start, step ,stop, delta, delay) wrote through with a second run of the code.
What is the point?
- config differential conductance
- setting_DC.png (40.48 KiB) Viewed 16114 times
- Keithley Applications
- Posts: 2849
- Joined: June 10th, 2010, 6:22 am
- Country: United States
Maybe something in the variables. I would look a the STEP command.
- 6221DIFCON.png (359.12 KiB) Viewed 16112 times
otherwise get error 416:
Who is online
Users browsing this forum: No registered users and 2 guests