Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.

two pole switching

7001, 7002 and Switch Cards
Post Reply
olorin17
Posts: 4
Joined: May 29th, 2014, 3:56 pm
Country: United States

two pole switching

Post by olorin17 » September 9th, 2014, 1:37 pm

Can anyone tell me how the 2 pole switching is done? i have a 7001 multiplexer, with a 7011-C card, and I need to know how to operate the switching from both the front panel and the remote commands. i.e. same bank, same input, but between the Hi/Lo poles, as indicated in the 7011-c manual. Thanks in advance!

Dale C
Keithley Applications
Keithley Applications
Posts: 2840
Joined: June 10th, 2010, 6:22 am
Country: United States
Contact:

Re: two pole switching

Post by Dale C » September 11th, 2014, 6:26 am

To close channel 1 of bank A on the 7011 card in the top slot.
1. Press SCAN LIST until the SELECT CHANNELS is displayed.
2. Enter in 1!1 from the keypad. Note all you have to do is press 1 twice.
3. Press CLOSE. This will close channel 1 of bank A on the 7011 card in the top slot.

To close channel 1 on bank A on the 7011 card in the top slot with remote control, send the following command.
:ROUTE:CLOSE (@1!1)

Post Reply

Return to “7000 Series Switch”

Who is online

Users browsing this forum: No registered users and 1 guest