Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.
Can't run SPC because of that, scope is running on default settings.
Running version 10.8.3 - anything I can do other than sending it to repair? (tentative repair that is as it's out of support)
- startup.png (45.42 KiB) Viewed 87 times
- spc.png (91.25 KiB) Viewed 87 times
- register 251.png (76.17 KiB) Viewed 87 times
Who is online
Users browsing this forum: No registered users and 3 guests