Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.

MDO3014 front panel dead

DPO/MSO/MDO4000 Series, DPO/MSO/MDO/TDS/THS3000 Series, DPO/MSO/TDS/TPS2000 Series, TBS/TBA1000 Series
Post Reply
imettt
Posts: 2
Joined: April 13th, 2017, 6:09 am
Country: Italy

MDO3014 front panel dead

Post by imettt » December 15th, 2018, 11:47 pm

Hi to everyone,
i've a problem with my MDO3014, the front panel (pot, leds and encoder ..)are completely dead, nothing cames.
Power supply are ok (12V for the probe, and 5V for local uP) but the uP doesn't starts any routine and the I2C from the main board after two or three times goes down because the is a conflict, i think the uP doesn't release the bus

My question is, the firmware update , now ver 1.26, could also update the uP of the panel which is a MC9S08AW32? or i need its bin?
There is a boot loader for that micro?
I would try to read that micro with freescale usb bdm programmer and clone it, is possible?

thanks in advance matteo

Post Reply

Return to “Non- Windows Based Oscilloscopes”

Who is online

Users browsing this forum: No registered users and 3 guests