Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.
The scope does not have any light indicator on the power button, but the other ones are emitted as per usual.
I looked into the front panel board and main board and there were no obvious hardware issues or their connections.
I have tried to force install the same firmware and the problem still persists. I have access to VISA and can write commands to the scope successfully. I ran the self test and the following things failed:
Before I send this in for repairs, has anyone had a similar problem and a solution they can share? Any other advice is greatly appreciated.
Who is online
Users browsing this forum: No registered users and 2 guests