Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.

Probe does not match test points

Post Reply
Kenson Ma
Posts: 3
Joined: August 23rd, 2016, 11:18 am
Country: United States

Probe does not match test points

Post by Kenson Ma » August 23rd, 2016, 11:20 am

I am using a 3.5 mm probe to observe the gate signal of my MOSFET, but I want to use a 2.5 mm test point to reduce the size of the whole system. The probe just can not fit into the test point. Is there any ways that I can use the 2.5 mm test points? Thanks!

David N
Tektronix Applications
Tektronix Applications
Posts: 525
Joined: July 31st, 2008, 8:26 am

Re: Probe does not match test points

Post by David N » August 29th, 2016, 9:03 am

There were not adapters that would reduce the 3.5mm to 2.5mm. Would suggest looking for P6130/31/33/34/35/36 or P6230/31 probes on the used market. These probes were 2.5mm.

Post Reply

Return to “Passive/Low Voltage”

Who is online

Users browsing this forum: No registered users and 2 guests