Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.

BNC to BNC x10 probes

Post Reply
Posts: 1
Joined: May 26th, 2021, 12:12 am
Country: France

BNC to BNC x10 probes

Post by iayestaran » May 26th, 2021, 12:35 am


In an industrial project, I need to connect the 4 channels of my oscilloscope to 4 BNC connectors in a panel.
I need to use x10 probes, as my tension values might rise up to 160V.

Do this kind of x10 BNC to BNC probes exist?
If needed, I could replace the BNC connectors in the panel with other connector types. Is any alternative preferred over BNCs?

Thanks in advance.

Posts: 1
Joined: July 19th, 2021, 10:09 am
Country: United States

Re: BNC to BNC x10 probes

Post by AlexisMori » July 19th, 2021, 10:31 am

Hi...On the off chance that you are discussing the test connector, it is fine. Or possibly I approved of them.

On the off chance that you are discussing separate connectors, I don't have the foggiest idea, it will presumably rely upon the provider, however I would not depend on them being really excellent.

Andrea C
Keithley Applications
Keithley Applications
Posts: 1601
Joined: October 15th, 2010, 10:35 am
Country: United States

Re: BNC to BNC x10 probes

Post by Andrea C » July 21st, 2021, 8:40 am

There are adaptors for your scope probe tip to be converted to BNC. Check your local electronics supply house.
You'd remove the spring loaded probe tip cover.
probe_tip_to_BNC.PNG (68.52 KiB) Viewed 622 times
This blog entry has some ideas:
https://www.tek.com/blog/accurate-measu ... -probe-tip

Post Reply

Return to “Passive/Low Voltage”

Who is online

Users browsing this forum: No registered users and 1 guest