Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.

TDP1000 can't auto zero on MSO58

Post Reply
Posts: 6
Joined: January 24th, 2015, 11:12 am
Country: Belgium

TDP1000 can't auto zero on MSO58

Post by OmironB » December 25th, 2020, 12:21 am

I have a TDP100 probe that works fine on an MSO4102B but can't auto zero on an MSO58. The offset voltage is around 280mV in the 4.25V range. If I put it in manual mode I can auto zero the 42.5V range fine, but not the 4.25 range.

Any ideas? Is the firmware on the MSO58 more strict about which offsets it accepts than earlier scopes? If so, why?

Post Reply

Return to “Differential”

Who is online

Users browsing this forum: No registered users and 1 guest