Problem on an old 475A

Questions in this forum area are community supported. Tektronix does not regularly monitor posts in this area.
Post Reply
Posts: 3
Joined: March 29th, 2018, 1:27 am
Country: Afghanistan, Islamic State of

Problem on an old 475A

Post by alierainy1230 » May 15th, 2018, 8:44 pm

I repaired a 475A, and all works except the Time/Div Delayed Sweep control. The rear cams do not engage when the knob is pulled out and turned. It appears to just slip inside the housing. Is this fixable? Will the switch for the 475 (which I can locate) work?
Thanks for your insight!

Post Reply

Return to “Other or Discontinued Oscilloscopes”

Who is online

Users browsing this forum: No registered users and 1 guest