Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.

TDS 420A firmware help, please.

Questions in this forum area are community supported. Tektronix does not regularly monitor posts in this area.
Post Reply
eurgenca
Posts: 1
Joined: September 17th, 2021, 6:28 am
Country: Slovenia

TDS 420A firmware help, please.

Post by eurgenca » September 17th, 2021, 6:57 am

Hello.
My first visit at this forum and I say hello to all users.

I got tek TDS420A with all LED's on.
At first startup I smell caps. In PS i found 1 bad cap and replaced it. I check all other cap's and looks O.K.
DSP battery was empty and replaced.
So PS running and all voltages are good.
Then I check 27K smd resistor on CPU board for reset and it is o.k.
On led diplay on cpu board it stops at "-" so cpu clearly running.
It is time to build console adapter and here is the problem:

Bootrom Header Checksum passed.
Bootrom Total Checksum passed.
BootRom Check Sum passed.
Bus Error Timeout test passed.
Bus Error Write to Bootrom passed.
GPIB Test passed.
Kernel Diagnostics Complete.

Calling SDM (monitor) Routine.

SDM (monitor) not enabled.
Enabling Bus Control register. Value = 0x2
Flashrom Programming Voltage is OFF.
Flashrom DSACK and JumpCode test passed.
Invalid Flashrom Body checksum = 0x9115, should be 0x9105

Flashrom Checksum test failed.
Cannot transfer control to Flashrom.
Transferring control to the SDM (monitor).


Can someone help me to resolve this problem.
I suppose firmware is corrupted, but I can't find firmware on net.
So if someone have firmware files and tell me how to flash this scope I'll be very glad.

Sebastijan.

strick
Posts: 291
Joined: March 22nd, 2016, 11:23 am
Country: United States

Re: TDS 420A firmware help, please.

Post by strick » September 22nd, 2021, 12:00 pm

Eurgenca,
attached is the TDS400A series firmware V1.0.2. You unzip, copy the files to a floppy and use GPIB to address the scope. there is a verify tool also.

Strick
Attachments
tds460fw.zip
(1.58 MiB) Downloaded 2 times

Post Reply

Return to “Other or Discontinued Oscilloscopes”

Who is online

Users browsing this forum: No registered users and 3 guests