Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.

DPO3000 Series Signal Path Compensation Error

Questions in this forum area are community supported. Tektronix does not regularly monitor posts in this area.
Post Reply
rotorrotor
Posts: 1
Joined: August 28th, 2020, 6:09 am
Country: Switzerland

DPO3000 Series Signal Path Compensation Error

Post by rotorrotor » August 28th, 2020, 6:33 am

I have a DPO3012 that fails SPC. The error log shows "280: 3 0 0" from calibration (no other errors).

The scope was running fine so far, I let it warm up for an hour and tried a few different times, but no luck. It says last successful run was 130 run-hours ago.

Has anyone got information about the error code 280?

Post Reply

Return to “Other or Discontinued Oscilloscopes”

Who is online

Users browsing this forum: No registered users and 5 guests