Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.


Post Reply
Posts: 1
Joined: December 1st, 2011, 2:07 am


Post by jyothishs » December 1st, 2011, 8:52 pm

Our organisation have purchased the P5210A for a high voltage project application. Since the systems are not ready i can't test the probe now. Can anybody suggest me a test setup for the validation of the probe. We have TDS5034B oscilloscope.

Chris B
Tektronix Applications
Tektronix Applications
Posts: 657
Joined: December 17th, 2010, 3:17 pm

Re: clarification

Post by Chris B » December 2nd, 2011, 8:51 am

If you have a generator, you could run through the performance verification listed in the manual for the probe.
http://www2.tek.com/cmswpt/madetails.lo ... 8648&lc=EN
The probe uses the Tekprobe interface, which your TDS5034B has.

Post Reply

Return to “Programming Support”

Who is online

Users browsing this forum: No registered users and 3 guests