Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.
I would like to get a screenshot of a frequency sweep (with RF, Freq/span, ampl, bw set) using the frequency group
on the Tektronix MDO3054 scope - I have the below to get a screenshot for channels one and three in the Vertical group,
but haven't figured out how to turn 'ON' the frequency/RF. Any help, pointers would be much appreciated
import pylab as pl
import numpy as np
# Below is Tektronix oscilloscope
scope.write('*cls') # clear ESR
Connect probe to oscilloscope Channel 1 and the probe compensation signal.
Press Enter to continue...
scope.write('*rst') # reset
scope.write('SELECT:CH3 0') # -- turns off display for ch 3
scope.write('SELECT:CH3 1') # -- turns on display for ch 3
raw_data = scope.read_raw()
fid = open('my_image.png', 'wb')
- Tektronix Applications
- Posts: 23
- Joined: August 3rd, 2016, 10:21 am
- Country: United States
Who is online
Users browsing this forum: No registered users and 8 guests