Page 1 of 1

External trigger save waveform

Posted: October 29th, 2018, 5:45 am
by dusty999
Hello,
I use a DPO4104B oscilloscope to store on an attached USB memory stick the waveform every n seconds (n>3s), for N times (N<1000). Could it be triggered the SAVE command (done by the SAVE push button) by some USB commands WITHOUT user intervention in some computer interface?
I do not use LabView, nor intend to do so.
I think about communication with a micro-controller capable of sending a set of characters over the USB port.

Thanks,
d999