Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.

Remote Control SCPI Cmd to Read Decoded Bus Data

Post Reply
mjjc12
Posts: 5
Joined: July 31st, 2019, 9:15 pm
Country: United States

Remote Control SCPI Cmd to Read Decoded Bus Data

Post by mjjc12 » July 22nd, 2020, 3:54 am

Hi,

I own both a DPO4k and DPO5k series with the correct embedded bus packages installed. I noticed that when I am working with i2c signals the scope can display onscreen decoded i2c data such as i2c address and i2c data.

However, I can't seem to find a scpi command that let's me read the decoded information, are there any available? The only ones I found related to i2c or any other bus protocol are just setup related.

Regards,
Mike

Post Reply

Return to “Programming Support”

Who is online

Users browsing this forum: No registered users and 1 guest