synchronization!!!

Post Reply
dangdongho3
Posts: 1
Joined: April 26th, 2018, 12:00 am
Country: United States

synchronization!!!

Post by dangdongho3 » April 26th, 2018, 12:02 am

I am working on a visible light communication test bed. A 10 MHz DMT signal from AWG is directly captured on DPO71604(via coax) in a back-to-back connection, and the signal after photo detection is also obtained on another channel. Since DMT error analysis is timing sensitive, I would like to know the timing offset (if any) between back-to-back and the signal post-detection. How can i calibrate this value?

Post Reply

Return to “General Discussion”

Who is online

Users browsing this forum: No registered users and 1 guest