'Wfm does not cross ref' message

Post Reply
mwbarth36
Posts: 1
Joined: August 17th, 2018, 7:11 am
Country: United States

'Wfm does not cross ref' message

Post by mwbarth36 » August 17th, 2018, 7:27 am

On many of the TDS scopes the message ' Wfm does not cross ref' appears for C1, C2, or both. These scopes may or may not pass some or all of the start up and calibrations tests. I cannot find the meaning or significance of this message in the service manuals. Can anyone explain the meaning of this screen message? Thanks!

Kiriakos
Posts: 6
Joined: September 1st, 2018, 11:27 am
Country: Greece
Contact:

Re: 'Wfm does not cross ref' message

Post by Kiriakos » September 1st, 2018, 12:28 pm

I suppose that Wfm this is the sort version of the word : Waveform.

Therefore the message could be that : Waveform this does not cross reference points ... possibly because signal amplitude this is not enough or higher than what it is required for calibration.

Post Reply

Return to “General Discussion”

Who is online

Users browsing this forum: No registered users and 1 guest