Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.

'Wfm does not cross ref' message

Post Reply
mwbarth36
Posts: 1
Joined: August 17th, 2018, 7:11 am
Country: United States

'Wfm does not cross ref' message

Post by mwbarth36 » August 17th, 2018, 7:27 am

On many of the TDS scopes the message ' Wfm does not cross ref' appears for C1, C2, or both. These scopes may or may not pass some or all of the start up and calibrations tests. I cannot find the meaning or significance of this message in the service manuals. Can anyone explain the meaning of this screen message? Thanks!

Kiriakos
Posts: 25
Joined: September 1st, 2018, 11:27 am
Country: Greece
Contact:

Re: 'Wfm does not cross ref' message

Post by Kiriakos » September 1st, 2018, 12:28 pm

I suppose that Wfm this is the sort version of the word : Waveform.

Therefore the message could be that : Waveform this does not cross reference points ... possibly because signal amplitude this is not enough or higher than what it is required for calibration.

robinperker007
Posts: 1
Joined: July 10th, 2019, 12:32 am
Country: United States

Re: 'Wfm does not cross ref' message

Post by robinperker007 » July 10th, 2019, 3:51 am

I was trying to print the error message but found that my canon printer offline windows 10 was showing every time and I need this to fix so that I can work with it. Please help me with the solution.

Post Reply

Return to “General Discussion”

Who is online

Users browsing this forum: No registered users and 3 guests