Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.

synchronization

Post Reply
KrisVS
Posts: 3
Joined: March 17th, 2017, 10:19 am
Country: United States

synchronization

Post by KrisVS » June 27th, 2017, 3:17 pm

I am working on a visible light communication test bed. A 10 MHz DMT signal from AWG is directly captured on DPO71604(via coax) in a back-to-back connection, and the signal after photo detection is also obtained on another channel. Since DMT error analysis is timing sensitive, I would like to know the timing offset (if any) between back-to-back and the signal post-detection. How can i calibrate this value?

Post Reply

Return to “General Discussion”

Who is online

Users browsing this forum: No registered users and 15 guests