Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.
I have been refurb/repair old tube radios for some time but haven't been able to work on any for about 9-10 years due to job constraints. Mostly working fab 5 sets and a lot of halicrafters, (S-19, S20, S22, S38-a-b-c, don't care much for the looks of the d or e variation) The Tek 465 I've been using for the projects has been sitting idle for almost 10 years. Other scope, Hitachi v-212 also sat same period.
Hitachi, all I did was plug her in and "Light the Fires" and all was good. No problems what-so-ever. Never even blinked. Hitachi never was finicky.
The tek 465 I feel might be a little different.
I have a variac but a person told me it is not good to bring a scope up on a variac. Something about maybe throwing out the amp circuits and also the calibration.
Would it be wise just to power it up normally?
Would hate to damage it. It has been a very good scope for me for over 22 years.
Bought a Siglent SDS1202X-E 2 weeks ago with the EEVblog discount from SAELIG, (Thanks tautech and SAELIG) to help me get out of the stone-age, but I worry about my 465.
Any suggestions will be thankful and considered
I didn't find the right solution from the internet.
https://www.eevblog.com/forum/testgear/ ... msg1301361
Who is online
Users browsing this forum: No registered users and 19 guests