Page 1 of 1

'Wfm does not cross ref' message

Posted: August 17th, 2018, 7:27 am
by mwbarth36
On many of the TDS scopes the message ' Wfm does not cross ref' appears for C1, C2, or both. These scopes may or may not pass some or all of the start up and calibrations tests. I cannot find the meaning or significance of this message in the service manuals. Can anyone explain the meaning of this screen message? Thanks!

Re: 'Wfm does not cross ref' message

Posted: September 1st, 2018, 12:28 pm
by Kiriakos
I suppose that Wfm this is the sort version of the word : Waveform.

Therefore the message could be that : Waveform this does not cross reference points ... possibly because signal amplitude this is not enough or higher than what it is required for calibration.

Re: 'Wfm does not cross ref' message

Posted: July 10th, 2019, 3:51 am
by robinperker007
I was trying to print the error message but found that my canon printer offline windows 10 was showing every time and I need this to fix so that I can work with it. Please help me with the solution.