Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.

Press 'Single' button on oscilloscope programmatically

Post Reply
IceCream
Posts: 3
Joined: November 19th, 2018, 7:01 am
Country: United States

Press 'Single' button on oscilloscope programmatically

Post by IceCream » December 3rd, 2018, 6:35 am

There is 'Single' button on Tektronix TDS 2024C oscilloscope front-panel.
Image
I cannot find in Programmer Manual how to press this button programmatically.
Please suggest what command should I use.

w2aew
Tektronix Applications
Tektronix Applications
Posts: 78
Joined: December 2nd, 2008, 2:27 pm
Country: United States
Contact:

Re: Press 'Single' button on oscilloscope programmatically

Post by w2aew » December 3rd, 2018, 7:19 am

First issue an ACQUIRE: STOPAFTER SEQUENCE
This will setup the Single acquisition.

Then, ACQUIRE:STATE ON will put the scope in Run mode, waiting for the trigger event.

Once the scope triggers, it will be stopped.

To re-arm the Single mode, issue ACQUIRE:STATE ON again...

Post Reply

Return to “General Discussion”

Who is online

Users browsing this forum: No registered users and 4 guests