I want to use Keithley 2700 DMM to take about 100 measurements (DCV, single channel) with a constant time interval. I use SCPI command in MATLAB scripts.
In order to control the time interval, I use the following commands:
However, the PC will receive only the latest reading.
How can I store all the 100 readings into the internal buffer, and receive all of them after the measurements?
- Keithley Applications
- Posts: 2849
- Joined: June 10th, 2010, 6:22 am
- Country: United States
Then when ready to take data send the
Then when you want the data send
That should send back all 100 points of measurement stored in the buffer when addressed to talk.
Hope this helps.
Who is online
Users browsing this forum: No registered users and 2 guests