Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.
In the next step, I will modulate and LED with the above DMT signal (from AWG) and detect it at the receiver. This requires synchronization and estimation for BER calibration. Since only a part of the DMT signal is acquirable, will this be a problem for signal recovery and calibration?
Right now, the signal detected from photo receiver module is unidentifiable due to noise and hence I could not find out what portion of the input signal is obtained after photo detection.
Can anyone help me on how to proceed for filtering and BER calibration?
Who is online
Users browsing this forum: No registered users and 10 guests