Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.

EMCVu Setup Wizard not recalling amplifier settings, RBW, or VBW

SignalVu-PC
Post Reply
coolguy9000
Posts: 1
Joined: September 7th, 2021, 5:49 pm
Country: Australia

EMCVu Setup Wizard not recalling amplifier settings, RBW, or VBW

Post by coolguy9000 » September 7th, 2021, 5:56 pm

I am using EMCVu.

When I save a project setup - amplifier settings, accessories, limit lines, RBW and VBW for ranges and limits, etc - using the Setup Wizard, and then recall the same project setup using the Setup Wizard, the amplifier settings, RBW and VBW are not set to their correct values (they are unchanged from previous state).

Is there some way to save and recall the setup which includes these settings or can this be added to the software?

Post Reply

Return to “SignalVu-PC”

Who is online

Users browsing this forum: No registered users and 2 guests