Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.
When initializing the scope we send a saved configuration, previously retrieved and saved using the "SET?" query, via USB using Tek VISA. In the past, with the older firmware, this has always worked. Since the firmware has been updated, this does not seem to work. Some communication commands seem to get dropped as all eight channels are active (displayed) as requested. I have experimented with waits between commands and a 1 millisecond wait does not fix the issue and greatly extends the time to send all of the commands to the scope. With flow control there should be no need for waits at all.
I have noticed that a known issue in this version of firmware is that the MSO 4 series has an unexpected timeout on VISA queries over USB; have any VISA over USB communications issues been reported in the 5 series?
Are there VISA settings that may cause this issue?
If this is a complete unknown, can we roll back our firmware to one that works?
Who is online
Users browsing this forum: No registered users and 2 guests