Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.

FYI... Keithley 2380 - Extra Step to Full Remote Operation

Series 2380 DC Electronic Loads
Post Reply
JBrown54
Keithley
Keithley
Posts: 19
Joined: December 14th, 2016, 10:42 am
Country: United States

FYI... Keithley 2380 - Extra Step to Full Remote Operation

Post by JBrown54 » September 11th, 2018, 6:06 am

It is not abundantly clear in the programming manual, but there are some additional commands you should be aware of when writing your automation code for remotely controlling your 2380 DC Electronic Load.

Code: Select all

SYSTem:REMote //This command sets the electronic load to remote control mode. 

Code: Select all

SYSTem:LOCal // This command sets the electronic load for control from the front-panel.
For LabVIEW programmers, you may find it useful to include the first command as part of your Initialize VI and the second as part of your Close VI.

omidi456
Posts: 1
Joined: November 17th, 2018, 7:57 am
Country: Iraq

Re: FYI... Keithley 2380 - Extra Step to Full Remote Operation

Post by omidi456 » November 17th, 2018, 8:01 am

But I still could not connect

Post Reply

Return to “Electronic Loads”

Who is online

Users browsing this forum: No registered users and 1 guest