Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.
I am reading a Keithley 2700 using a Lantronix, accessing with SCPI commands.
I have a card behind, with 2 temperature sensors, and I would like to read them.
I tried to use these commands:
The problem is that I am reading some bytes back, and the typical output that I can have is a string similar to this one:
The problem is: sometimes I have just part of this string, and sometimes I cannot properly take the correct number out of the string.
Is there a way to have only the measurement, nothing else, and always of the same bytes length ?
Thanks for any suggestion
PS I am using python with the socket library
the *RST default delivers reading, unit, reading number and time stamp.
To select reading only just place the following command after the *RST command:
Who is online
Users browsing this forum: No registered users and 4 guests