Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.
The 2700 has firmware B09 installed.
I have attached the eeprom images from both my 7703 and 7705 - can someone verify the 7703 image is corrupted and if so correct it for me or provide a good image for me to try.
- (575 Bytes) Downloaded 1098 times
I am not able to open or close the relays, the 2700 acts as though the 7703 is not plugged in at all.
My 7705 module does indicate as being detected at power on and I can open and close it's relays.
- Keithley Applications
- Posts: 402
- Joined: June 10th, 2013, 6:00 am
- Country: United States
I will see if we can send the file to you. It may require a couple of days to track down exactly where to find a copy of the file.TheSteve wrote:I determined there is a checksum error in the upper portion of the 7703 eeprom. The checksummed range is from 0x10 to 0x66. If I correct the checksum the card is recognized but doesn't work properly. I can't toggle any relays. Does anyone have an example of a 7703 card eeprom? I'd really like to use this card.
I don't even need a full image, just bytes 0x10 through 0x68 to patch into my file. that way the relay count and serial number are maintained.
Who is online
Users browsing this forum: No registered users and 5 guests