Page 1 of 1

LabVIEW and Keithley 2700, fast single read

Posted: July 27th, 2017, 2:54 am
by KapitanBomba
Hi all,

I have a question: Is it possible to accelerate measurement when is used a single read?
I mean, i have a for loop in LabVIEW, with iteration = 40 (the number of channels in keithley's card), and in every iteration, i have a single read. It works, but very slow. Is it possible to accelerate without change to multi read?

Regards

Re: LabVIEW and Keithley 2700, fast single read

Posted: August 1st, 2017, 5:31 pm
by Andrea C
Use fixed measure range and small nplc setting.

If speed is an objective, using a scan rather than single point reads will always win.