Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.

Can i connect 2300 power supplies in series?

2302, 2303, 2303-PJ, 2304, 2306, 2306-PJ, 2306-VS, 2308
Post Reply
ctraines
Posts: 1
Joined: August 8th, 2014, 7:16 am
Country: United States

Can i connect 2300 power supplies in series?

Post by ctraines » August 8th, 2014, 7:37 am

I need a 22V battery simulator. Can I put 2 2300 power supplies in series?

Dale C
Keithley Applications
Keithley Applications
Posts: 2842
Joined: June 10th, 2010, 6:22 am
Country: United States
Contact:

Re: Can i connect 2300 power supplies in series?

Post by Dale C » August 8th, 2014, 1:49 pm

Per our spec, for this whole series (you will find the spec under General), the isolation (Low-Earth) is 22V. So you could series two units but max voltage cannot exceed 22V. If you exceed that, damage to the supplies could result.

sanimirza

Re: Can i connect 2300 power supplies in series?

Post by sanimirza » December 22nd, 2014, 3:26 am

Hi Forum,

I have a 2303-PJ with firmware A03/B01, while calibrating it turned out the manual was not telling the proper things, calibration for the 500mA range I only could to by using the 4 Ohm resistor and was not possible with the 30 Ohm as was stated in the manual..

Dale C
Keithley Applications
Keithley Applications
Posts: 2842
Joined: June 10th, 2010, 6:22 am
Country: United States
Contact:

Re: Can i connect 2300 power supplies in series?

Post by Dale C » December 22nd, 2014, 11:52 am

Checking with service on this issue.
I will post when it is answered.

Dale C
Keithley Applications
Keithley Applications
Posts: 2842
Joined: June 10th, 2010, 6:22 am
Country: United States
Contact:

Re: Can i connect 2300 power supplies in series?

Post by Dale C » December 22nd, 2014, 12:11 pm

4ohm for 500ma adjust
The manual is wrong..

Post Reply

Return to “Series 2300”

Who is online

Users browsing this forum: No registered users and 4 guests